Magnum Venus Plastech Hypaject MK III - Manual (Page 17)

Hypaject MK III Instructions Issue 07: April 2001-04-23 17
4. Place waste container under load pipe. Close inject valve. Ensure homogeniser
pressure is set to zero. Switch homogeniser to pressure.
5. Open load valve and allow resin to flow into waste container.
6. Close load valve. Switch homogeniser to vacuum.
7. Place Autosprue waste hose into a container of solvent. Switch homogeniser to vacuum.
8. Open inject valve and allow a sufficient quantity of solvent to be loaded through the
injection hose.
9. Close inject valve. Allow solvent to circulate inside homogeniser under vacuum for 2-3
minutes.
10. Ensure homogeniser pressure is set to zero. Switch homogeniser to pressure. Open
load valve and allow solvent to drain from homogeniser into waste container.
11. Repeat steps 7-10 if necessary.