Magnum Venus Plastech UPMS-1000 Monitoring System - Manual (Page 25)

OPERATIONS MANUAL
UPMS-1000-XXX
MAGNUM VENUS PLASTECH REV 1.02
NOVEMBER 2010 PAGE 25
10. Cycle display using the MODE button, until the
RATE B is displayed.
11. Press and hold the ENT button until the display enters program mode. At this point you should
see KFR B VALUE , with a number underneath it. The first digit should be blinking.
12. Using the UP or DN and SEL buttons adjust the KFR B VALUE to figures calculated from
above.
13. Press ENT to accept KFR B VALUE setting. This will then move to the next screen.
14. Press ENT to accept SAMPLE B setting.
15. Note: Do not adjust the SAMPLE A SETTING!
16. Press ENT to accept ENG UNITS B setting.
17. Note: Do not adjust the SAMPLE A SETTING!
18. Calibration for RATE B is now complete.
After this is complete, a test sample should be dispensed into a cup and timed while noting the reading on
the display. If the desired result is not achieved it is possible to adjust the KFR factor in small increments
to match the output of the dispensing unit.