Magnum Venus Plastech GMX-2000 GRANIT COAT GUN - Manual (Page 6)

6
pliable and to keep material drag-thru soft. Material drag-thru that is allowed to harden,
will score the piston rod. This will create excessive leakage and rapid packing wear.
Disassembly should be done on a clean work bench with clean cloths to keep parts
clean.
If replacement parts are necessary, consult Parts List for identification.
Before assembling, lubricate parts where required. When assembling O-rings, or parts
adjacent to O-rings, care must be exercised to prevent damage to O-ring and O-ring
groove surfaces.
If you have any questions about safety or procedures, contact your Magnum Venus
Products’ representative.
CAUTION: Materials and solvent being pumped must be compatible with the parts of
the pump that becomes wetted when in contact with material or solvent. Wetted parts
consist of the following: stainless steel, copper, brass, steel, gray iron, leather, Teflon
and Vellumoid.
CAUTION: Keep solvents away from heat, sparks and open flames. Keep containers
closed when not in use.