Retain this instruction sheet for future reference – Mallory Ignition LAKEWOOD REAR LOWER CONTROL ARMS 20105 User Manual

Page 2

Advertising

Note: Clean and lubricate axle and chassis control
arm mounting brackets with a good quality chassis
grease to ease installation.

7. Tighten front and rear control arm mounting bolts to

80 ft./lb. torque.

Note: The adjustable feature of this arm enables you
to correctly locate the rear end in relation to the
chassis and to compensate for altered ride heights.

8. Follow the same above procedure for installation

of Adjustable Control Arm on other side of vehicle.

9. Lubricate control arm bushings with a good quality

chassis grease.

10. Once arms are installed you can begin to adjust.

11. The pinion angle must now be checked and adjusted if

necessary. The angle between the drive shaft and the
rear end yoke must be between 4 and 6 degrees down.

12. With pinion angle set, tighten all fasteners securely.

13. Install wheels and properly tighten lug nuts to

wheel manufacturers specifications.

14. Carefully remove support stands and lower vehicle

to ground.

THIS COMPLETES THE INSTALLATION.

YOU CAN NOW ROCK-N-ROLL!

IMPORTANT!

Periodically check to make sure that all mounting

hardware is securely tightened. Use a good

quality chassis grease to keep bushings and

sleeves properly lubricated.

TECHNICAL SERVICE

A highly trained technical service department is

maintained by Lakewood Industries to answer your

technical questions, provide additional product

information and offer various recommendations. See

your local retailer of Lakewood products for specific

prices. For best results, technical service calls,

correspondence and warranty questions should be

directed to the following address:

Lakewood Industries

10601 Memphis Ave. #12

Cleveland, Ohio 44144

Phone 216-688-8300

8:30 A.M.-5:00 P.M. EST

www.lakewood-industries.com

RETAIN THIS INSTRUCTION SHEET FOR FUTURE REFERENCE.

97140082

Advertising