Arkon TT123 - Manual (Page 2)

TT123 | Cup Holder Mount for TomTom GPS
Step 1.
Step 1.
Slide the adapter plate up into the grooves on the
back of the TomTom ONE, ONE XL, or ONE XL • S.
Attach the device cradle to the pedestal by inserting
the dual T-Tabs of the pedestal (E) into the T-slots of
the adapter plate (F).
TomTom ONE and ONE XL Device Attachment
E
Step 1.
Step 2.
Attach the adapter plate by sliding it up into the slot
on the back of the TomTom GO 520, 530, 720, 730, 920,
920T, or 930 model device as shown below.
Follow step from Device Attachment at the lower right.
TomTom GO Adapter Plate Instructions TomTom ONE and ONE XL Adapter Plate Installation
F
!
Safety Precautions
Do not install Arkon products over an air bag cover or within the air
bag deployment zone. Arkon Resources, Inc. assumes no responsi-
bility of liability for injury or death as a result of car crashes and / or
air bag deployment.
Arkon is not responsible for any damages caused to your car, your
device, or yourself due to the installation or use of this pedestal mount.
The Mobile Mounting Specialists™
www.arkon.com
Arcadia, CA 91006 USA
Designed in USA | Made in Taiwan
© Copyright 2008 Arkon Resources, Inc.
Consumer Hotline:
USA (800) 841-0884
INT’L (626) 254-9005
Monday - Friday 9 am - 5 pm, PST