Mallory Ignition Mallory HEI REMOTE COIL ADAPTER 29049_29050 - Manual

HEI REMOTE COIL ADAPTER
INSTALLATION INSTRUCTIONS
FORM 1220 (REV. E) 9/03
Step 1
Disconnect the battery (–) cable to cut power to the
system until installation is complete.
Step 2
Disconnect the distributor plug (w/3 wires),
12-volt/ignition switch plug (w/1 wire) and tach lead
(if equipped) from the distributor cap. See Figure 1.
Step 3
Remove the spark plug wire retainer and the coil
cover.
Step 4
Remove the HEI coil from the distributor cap. Do
not remove the carbon brush with spring or the
rubber washer.
Step 5
Install the Mallory external coil adapter. Secure using
the original coil cover screws. Install the Mallory
spark plug wire retainer using the screws provided.
See Figure 1.
Step 6
Connect the distributor plug and 12-volt/ignition
switch plug to the Mallory adapter/harness provided.
Continue wiring the Mallory adapter harness as
shown in Figure 2 or 3. Connect the
battery (–) cable.
MALLORY IGNITION www.mrgasket.com 1
FIGURE 1
FIGURE 2
(DISCONNECT)
ORIGINAL COIL
COVER SCREWS
DISTRIBUTOR CAP
MALLORY SPARK
PLUG WIRE RETAINER
MALLORY
EXTERNAL
COIL ADAPTER