Coil – Mallory Ignition Mallory unilite conversion kit 502m User Manual
Page 4
4
MALLORY IS A DIVISION OF THE MR. GASKET PERFORMANCE GROUP
550 MALLORY WAY, CARSON CITY, NEVADA 89701
(775) 882-6600
FAX (775) 887-4326
www.mrgasket.com
FORM #1263M
(REV. F) 01/01
Made in U.S.A.
Printed in U.S.A.
FIGURE 3
COIL
–
+
GROUND TO
ENGINE BLOCK
RED
DISTRIBUTOR
(TYPICAL)
NOTE: When using the UNILITE
®
distributor with a HYFIRE
®
or other
aftermarket amplifier box, connect the distributor according to the
amplifier box instructions.
A PROMASTER
®
coil is shown for illustration purposes. When using
a stock coil, connect it in the same manner shown.
TO IGNITION SWITCH
BROWN
GREEN
OEM PRIMARY
RESISTANCE WIRE
DISTRIBUTOR
WIRE HARNESS
You must use suppressor coil wire
COIL
–
+
DISTRIBUTOR
(TYPICAL)
NOTE: When using the UNILITE
®
distributor with a HYFIRE
®
or other
aftermarket amplifier box, connect the distributor according to the
amplifier box instructions.
A PROMASTER
®
coil is shown for illustration purposes. When using
a stock coil, connect it in the same manner shown.
TO IGNITION SWITCH
BROWN
GREEN
MALLORY BALLAST
RESISTOR PN 700
OR OEM BALLAST
DISTRIBUTOR
WIRE HARNESS
You must use suppressor coil wire
GROUND TO
ENGINE BLOCK
RED
FIGURE 4