Mallory Ignition Mallory WINDOW RPM ACTIVATED SWITCH 628 - Manual (Page 6)

0 7 5
ST
ANDARD
ST
ANDARD
GREEN
BLACK
ORANGE
PURPLE
RED
TO ENGINE BLOCK OR CHASSIS GROUND
TO ENGINE BLOCK OR CHASSIS GROUND
DO NOT CONNECT TO COIL + TERMINAL
TO T
ACH
CONNECT IGNITION COIL AND DISTRIBUTOR/TRIGGER WIRES ACCORDING TO
THE
HYFIRE VII INSTRUCTIONS APPLICABLE TO THE DISTRIBUTOR/TRIGGER B
EING USED
®
DO NOT CONNECT TO COIL +
CONNECT THESE WIRES TO A SWITCHED 12 VOL
T SOURCE.
SWITCH MUST BE CAP
ABLE
OF SWITCHING ALL OF THE CURRENT FROM THE IGNITION AND DEVICE(S).
THE IGNITION MA
Y DRA
W UP
TO 1/2 AMP
. MINIMUM OF 18 GA
WIRE SHOULD BE USED.
CONNECT THIS WIRE TO THE DEVICE TO BE TURNED ON A
T A SELECTED
RPM. CONNECT THE OTHER WIRE FROM THE DEVICE TO THE GROUND. CONNECT THIS WIRE TO THE DEVICE TO BE TURNED ON A
T A SELECTED
RPM. CONNECT THE OTHER WIRE FROM THE DEVICE TO THE GROUND. NOTE: RELA
YS ARE REQUIRED IF THE DEVICE
BEINGSWITCHED DRA
WS MORE THAN 5 AMPS.
T
HES RELA
YS ARE SHOWN AS EXAMPLES
ONL
Y. OTHER RELA
YS MA
Y BE USED SUCH AS
BLUE STREAK P
AR
T NO. R
Y -48.
P
AR
T NO. 628
WINDOW
RPM
ACTIV
A
TED
SWITCH
®
RPM A
CTIV
A
TED SWITCH AND RELA
YS
WITH HYFIRE
®
VII
6
FIGURE 4