Mallory Ignition ACCEL Digital Fuel Injection Engine Management System 74030 - Manual (Page 10)

8
ACCEL/DFI
-
Red/White to Fuel
pump Positive (+)
Pink Wire to 12V
Switched on Fuse Box
5 PIN Grey
Connector to Main
Harness
2 PIN Black
Connector to Water
Temp Sensor
2 PIN Grey
Connector to
Optional Air
Temp Sensor
4 PIN Black
Connector to be used
only with a computer
controlled distributor
3 PIN Black
Connector to
TPS Sensor
Only connect white wire to
negative (–) side of ignition coil
when using a non-computer
controlled distributor. See
installation instructions if using
Mallory or ACCEL 300+
4 PIN Black
Connector to
IAC Motor
3 PIN Green
Connector to
MAP Sensor
5 PIN Black
Connector to Injector
Harness (Male)
Firewall
Grommet
3 PIN Black
Connector to O2
Sensor
+
To 6 PIN Jumper Harness to interface
between 4 PIN Main Wiring Harness
Connector and 6 PIN Thick Film Module
(TFM) Connector on Computer
Controlled Distrubutor
Only connect black wire to
negative (–) side of ignition coil when
using a computer controlled distributor.
See installation instructions if using
Mallory or ACCEL 300+
Black, Purple/Black,
Black/White wire
MUST GO DIRECTLY
to Battery Ground (-)
Red wire MUST GO
DIRECTLY to Battery
Positive (+)