MAX RB397(USA) - Manual (Page 7)

8
16 This charger is not intended for use by
children or disabled persons without
supervisor.
17 Children should be supervised to en-
sure that they do not play with the
charger.
18 Put a pack cap on the terminal of the
Battery pack
When the Battery pack is not in use, put a
pack cap on its terminal to prevent short
circuits.
19 Do not let the terminal (metal compo-
nent) of the Battery pack short-circuit
A short circuit in the terminal will generate
a large current, causing to overheat the
Battery pack and become damaged.
20 Do not leave or store the tool in a vehi-
cle or in direct sunlight during sum-
mer. Leaving the tool in high
temperature conditions may cause the
battery pack to deteriorate.
21 Do not store a fully discharged battery
pack. If a fully discharged battery pack
is removed from the system and left for
a long period of time, it may become
damaged. Recharge the battery imme-
diately when it has been discharged.
18. WEAR SAFETY GLOVES WHILE OPER-
ATING THE TOOL
The finish tie has sharp edges. To avoid seri-
ous injures, be careful not to touch the sharp
edges. MAX recommends wearing OSHA
approved safety gloves while operating the
tool.
2. SAFETY FEATURES
In order to ensure safety during operation, the
RB397 has the following safety features.
• Prior to using the tool, make sure that the
safety features function properly. If they do
not, avoid using the tool.
Trigger Lock
The Trigger can be locked preventing the tool
from operating for safety. Always keep the Trig-
ger locked when not in use.
Unless you are at tying work, set the trigger lock
to the position of LOCK and remove a battery
pack. When you start tying work, set it to the po-
sition of UNLOCK.
Pull to the left slightly and upwards to UNLOCK.
WARNING
Trigger
Trigger Lock