Set up procedure for wet pickup – Minuteman X380-15 Hospital Vacuum User Manual
Page 6
Parts and Instruction Manual
Page 3
(Refer to “Wet Pickup Assembly”)
1.
Loosen lid latches and remove vacuum lid from tank.
2.
Remove filter bag and filter bag protector from tank.
3.
Empty tank of all debris. Wipe down inside of tank with wet towels to remove all traces of dust.
4.
Place water shut off assembly #6 into tank, centering gasket around tank rim.
5.
Place ring adaptor #5 onto tank and clamp down with lid latched on tank.
6.
Before placing vacuum motor lid assembly #1 onto tank, check to be sure there is a clean pre-filter on the outside
of the filter. Place motor lid on tank and secure with lid latches.
7.
Water shutoff will allow you to recover approximately 10 gallons of water before you are required to empty tank.
8.
To empty tank, remove vacuum lid assembly, adaptor and water shutoff. An optional dump valve is available for
installation on the vacuum tank.
9.
When converting vacuum to dry recovery, the tank must be completely dry before installing filter bag protector
and cloth bag filter.
10. The Lint trap bag (refer to “Water Shut Off Assembly”), should be removed and rinsed out when necessary.
Detach and remove the spring retainer to remove bag.
SET UP PROCEDURE FOR WET PICKUP