Minuteman M12230 Port A Scrub - Manual (Page 3)

The Minuteman Machine is an ideal machine to clean floors in small and
medium areas like offices, hospitals, restaurants, shopping complexes and many commercial applications. It
sprays plain water / detergent solution, scrubs and picks up the dirty water - all in a single pass. The Port A
Scrub has different optional brushes to suit a variety of applications. This machine can be used only on smooth
even floors like Mosaic, all type of stone floors, PVC, Short-pile carpet, Wood and Profiled Rubber. It should not
be used on rough uneven surfaces. .
PORT A SCRUB
Product Information
Important Safety Instructions
Instruction Manual
Please read the following instructions completely before operating the machine. Any violation of the
same will not only invalidate the warranty, but also may result in a safety hazard.
The machine must be unpacked and assembled in accordance with these instructions before connecting to
the electrical supply.
This machine should always be connected to a fully grounded power supply of the right voltage and
frequency.
Keep the power supply cord away from moving parts. During operation, hazard may occur when running
machine over the supply cord.
The machine must be disconnected from the mains supply (by pulling the plug out) before changing the
brushes, cleaning the machine and, for maintenance.
Warning! Use only the brushes/accessories strictly as per the instruction manual. Usage of any other
brushes/accessories can cause safety problems.
Periodically inspect the cord for possible damage. The damaged cord must be replaced with the special cord
available from the manufacturer or an authorized service agent.
DO NOT leave the machine connected to the power supply when not in use; always remove the plug from
the mains socket.
DO NOT use where hazardous dust is present.
DO NOT use machine near flammable liquids.
DO NOT use in an explosive atmosphere.
DO NOT use in gradient surface.
DO NOT keep the machine with handle lowered, when the machine is in working mode.
Operators must be fully trained in accordance with these instructions, able to perform routine upkeep of the
machine and correct selection of brushes.
Operators should be physically capable to maneuver transport and operate the machine.
DO NOT run the machine dry, as this could damage the floor surface or the machine itself.
Take adequate care to hold the machine firmly while installing and removing the brush.
Never use excessive foaming or highly corrosive cleaning solutions.
While operating on a flooded floor, always ensure that the water level does not exceed 1/4”.
DO NOT operate this machine on rough uneven surface like industrial concrete floor.
Do not clean the machine using water jet.
Ensure all parts are fitted properly before operation.
·
·
·
·
·
·
·
·
·
·
·
Guidelines for the operator
·
·
·
·
·
·
·
·
·
3