Minuteman C70555-56 705 Series Industrial Air Operated - Manual (Page 2)

1
MODEL 705 SINGLE VENTURI MODEL 705 SINGLE VENTURI MODEL 705 SINGLE VENTURI MODEL 705 SINGLE VENTURI MODEL 705 SINGLE VENTURI
AIR OPERA AIR OPERA AIR OPERA AIR OPERA AIR OPERATED WET/DR TED WET/DR TED WET/DR TED WET/DR TED WET/DRY Y Y Y Y V V V V VACUUM ACUUM ACUUM ACUUM ACUUM
OPERA OPERA OPERA OPERA OPERATING INSTRUCTIONS TING INSTRUCTIONS TING INSTRUCTIONS TING INSTRUCTIONS TING INSTRUCTIONS
INSPECTION INSPECTION INSPECTION INSPECTION INSPECTION
Carefully unpack and inspect your machine for shipping damage. Each unit is tested and thoroughly
inspected before shipment, therefore, any damage is the responsibility of the delivering carrier who
should be notified. Read all instructions carefully before operating.
SPECIAL SPECIAL SPECIAL SPECIAL SPECIAL W W W W WARNING ARNING ARNING ARNING ARNING
Air operated equipment can generate static electricity during use. Static dissipating arcing can be
generated and occur if equipment and accessories are not grounded. Risk of explosion is possible
if operated near explosive materials or vapors. Do not operate this equipment near flammable
materials such as solvents, thinners, fuels, grain dust, etc.
AIR PRESSURE AIR PRESSURE AIR PRESSURE AIR PRESSURE AIR PRESSURE AND C.F AND C.F AND C.F AND C.F AND C.F.M. VOLUME REQUIRED .M. VOLUME REQUIRED .M. VOLUME REQUIRED .M. VOLUME REQUIRED .M. VOLUME REQUIRED
For maximum performance, operate with requirements listed below:
Model Air Supply Line Maximum Pressure C.F.M.
705 Single Venturi 1/2" 100 46
Air pressure control valve can be regulated to operate with lower pressure and C.F.M. when maximum
is not required. OPTIONAL: Air pressure regulator can be attached at air valve for positive air pressure
and C.F.M. control.
ASSEMBL ASSEMBL ASSEMBL ASSEMBL ASSEMBLY Y Y Y Y PROCEDURE FOR MODEL PROCEDURE FOR MODEL PROCEDURE FOR MODEL PROCEDURE FOR MODEL PROCEDURE FOR MODEL 705 WET/DR 705 WET/DR 705 WET/DR 705 WET/DR 705 WET/DRY Y Y Y Y V V V V VACUUM ACUUM ACUUM ACUUM ACUUM
1. For wet recovery, attach float assembly #515003, page 4, to underside of vacuum lid with #710359
screw and washer #711543 provided.
2. For dry recovery, attach filter bag assembly #805047, page 5, to underside of vacuum lid. Float
assembly already attached does not have to be removed. To attach filter, refer to page 8 for
assembly.
Always remove the filter bag assembly when vacuum is used for wet recovery.