Here i’m in command, Understanding the control panel, Argherita – Ariston AWD 12 User Manual

Page 4

Advertising
background image

M

ARGHERITA

Margherita - Instructions for installation and use

I

G

L

F

E

H

N

M

O

A

B

C

D

Stain removal (see page 8)

Thanks to this command, Mar-

gherita will carry out a more in-

tensive wash that optimises the

effectiveness of the liquid

additives, thus allowing more

resistant stains to be removed.

When you press the stain removal

button, you cannot activate the

pre-wash cycle (I).

Prewash

With this button, you can pre-

wash on all programmes except

the wool programme and the

special programmes (see page 4).

If you use this function, you

cannot use the stain removal

button (H).

On-off

When button L is pressed, the

washer-dryer is switched on,

when it is not the machine is

switched off. Turning the

appliance off does not cancel

the selected programme.

On-off lamp / door locked

Lamp M flashes slowly when the

appliance is switched on and

awaiting instructions and at the end

of a cycle, indicating that the door

can be opened. It flashes quickly

when the door should not be

opened. A steady light means the

appliance has accepted the selected

programme.

Drying cycle lamp

When this lamp is on, it means

that knob C has been set on a

drying cycle and at the end of the

wash cycle, the appliance will run

the selected tumble drying cycle.

The washer-dryer is equipped

with extra compartment 4

(provided) for the bleach, to be

inserted in compartment 1.

Programme key

This contains the descriptions of

the wash programmes and the

various functions connected to

the buttons. Pull it outwards to

open it.

Rinse-hold

This button allows you to interrupt

a programme (on symbol )

keeping the washing soaking in

water before the spin cycle. It is a

very useful button in particular

because it can be used for

delicates and synthetics. It is only

to be used with wash programmes

for synthetic fabrics, silk and

curtains when it is impossible for

you to take the washing out

immediately. Before opening the

washing machine door, finish the

wash cycle as follows:

Silk and curtains: press button F

and Margherita will drain the

water.

Synthetic fabrics: press button F

if you want a spin cycle, or turn

knob A to symbol if you want

the water to be drained.

N.B.:

- when setting a drying cycle,

this function is not performed.

- With "Daily wash" or "Hand

wash", this function is not

performed.

Slow spin

Use this button to reduce the

spinning speed from 1200 to 600

rpm for the cotton programmes

and from 850 to 600 rpm for the

synthetic fabrics programmes.

Here I’m in command

Understanding the control panel

Making the right choice is important. And it’s easy.

Margherita’s knobs are hidden. Just

press them lightly in the middle to

extract them.

Programme selector knob

and programmed start

Use this knob to select the wash

programme.

Turn this knob clockwise only.

To select a programme, you

should turn the knob so that the

symbol/number of the desired

programme is in line with the

pointer on the glass O.

Now press on/off button L

(position ON), pilot lamp M will

start flashing.

After 5", the setting will be

accepted, pilot lamp M will stop

flashing (staying lit) and the wash

cycle will begin.

Should you wish to interrupt the

programme in progress or set a

new one, select one of the

symbols

(Stop/Reset) and wait

5" : when the cancellation has

been accepted, pilot lamp M

flashes, and you can then turn the

appliance off.

You can use this knob to delay

the appliance's operation.

Select one of the 3 delay time

positions, press the on/off button

L (position ON) and wait 5". The

setting has now been accepted

(pilot lamp M stays lit) and you

can select the programme you

desire.

Pilot lamp M has a particular

flashing motion (2" on and 4"

off) to indicate that a delayed

start has been set.

During this phase, you can open

the appliance door and change

the washing load, should you

wish to do so.

After the wash cycle has been set

and accepted by the washer-

dryer, turning the knob will have

no effect (except for when it is

on position Stop/Reset).

Temperature control knob

It is used to set the wash tempe-

rature indicated in the

programme table. It also allows

you to reduce the temperature

recommended for the selected

programme, and even to set a

cold wash cycle ( ).

Drying cycle knob

Use this knob to select the desired

drying cycle. Two options are

available:

A - Based on time:

From 40 minutes to 150.

B - Based on the damp level of

the dry clothes:

Iron : slightly damp clothes,

easy to iron.

Wardrobe : dry clothes to put

away.

Extra dry : very dry clothes,

recommended for towelling and

bathrobes.

A cooling stage is foreseen at the

end of the drying cycle.

Detergent dispenser

It is divided into three

compartments:

1. Detergent for pre-washing;

2. Detergent for the wash cycle;

3. Fabric softeners,

starches, perfumes.

The detergent dispenser with
the additional bleach
compartment is here.

3

MAX

1

2

4

3

Advertising