Minuteman C46200-02CE Carpet Spotter - Manual (Page 5)

3
USER MAINTENANCE INSTRUCTIONS USER MAINTENANCE INSTRUCTIONS USER MAINTENANCE INSTRUCTIONS USER MAINTENANCE INSTRUCTIONS USER MAINTENANCE INSTRUCTIONS
All service and repair should be performed by qualified vacuum service representative or electrician.
No user serviceable components are employed in the electrical vacuum lid head assembly. No
lubrication of the motor is required.
DAIL DAIL DAIL DAIL DAILY Y Y Y Y MAINTENANCE MAINTENANCE MAINTENANCE MAINTENANCE MAINTENANCE
1. Solution tank should be emptied after each use. Flush pumping system with 1 gallon of clean
water after use.
2. Check and clean vacuum inlet and solution inlet strainer daily.
3. Removable recovery tank, page 7, item 30, should be rinsed clean daily.
4. Spray jet should be checked for correct spray pattern and cleaned if plugged. Do not clean out
spray tip with pins or wire, this may cause damage to the jet spray pattern and cause streaking.
5. Protect equipment from freezing. Severe pumping system damage can occur if allowed to freeze.
6. Inspect vacuum hoses for tight connections. Check electrical cable for abrasion or cuts in jacket.
Cord should be replaced if worn or damaged.
MONTHL MONTHL MONTHL MONTHL MONTHLY/BI-MONTHL Y/BI-MONTHL Y/BI-MONTHL Y/BI-MONTHL Y/BI-MONTHLY Y Y Y Y MAINTENANCE MAINTENANCE MAINTENANCE MAINTENANCE MAINTENANCE
The Solution Pump System should be purged monthly to remove alkaline residue build-up. To flush
system out, use 1 quart of white vinegar to 1 1/2 gallons of clean hot water, followed by a clear 1 1/2
gallon rinse. Clean spray jets if required.
CORD STORAGE CORD STORAGE CORD STORAGE CORD STORAGE CORD STORAGE
While not in use storage can be accomplished by winding cord around top of machine. Cord hooks
are provided.
• Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped,
damaged, left outdoors, or dropped into water, return to service center.
• Do not pull or carry by cord, use cord as handle, close a door on cord, or pull cord around sharp
edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
• Do not unplug by pulling cord. To unplug, grasp the plug, not the cord.
• Do not handle plug or appliance with wet hands.
This equipment should be stored indoors and not exposed to rain.