Mirion Technologies MDR My Dose Record - Manual (Page 2)

DATASHEET LIT4301_4_US
2652 McGaw Avenue
Irvine, CA 92614 USA
Web: https://dosimetry.mirion.com
U.S./Canada +1.800.251.3331
U.K. 0170.629.9329
Worldwide +1.949.419.1000
MDR REGISTRATION
Step 1: Launch your web browser and enter the following web address: www.mirion.com. Click on the Dosimetry Services Division tab. This will
open the landing page for the Dosimetry Services Division. From this page click :”My Dose Record login” and you will be directed to a login page.
Step 2: Register as a New User. To register as a new user,
you will need to have one of your badges in front of you. Enter
your e-mail address and your unique badge ID.
How to locate your unique badge ID:
• Film wearers- you will need to combine the badge type
along with the unique badge ID number to make up your
Unique Badge ID for login. Open the badge holder, the badge
type is the number 01 (in some cases you may see an 02 or
03), which is to the left of the region of body monitored (WB).
Your unique badge ID is the 6-digit number located under the
barcode.
For example, using the film label below, you would
enter 01Z99999 for the Unique Badge ID.
• TLD wearers- this is a 10 digit number located under the
barcode.
For example, using the TLD label below, you would
enter 1495926402 for the Unique Badge ID.
• Ring wearers- you will need to enter the 10 digit unique
badge ID #. For MeasuRing wearers this number is located above the barcode and starts with the number 19. For Ultra ring wearers this
number is located below the barcode and starts with the number 18.
Once you have entered your information, click the “go” button, to be directed to the Terms and Conditions. You must accept the Terms and
Conditions to use MDR. Once you click “I Accept”, a temporary password will be e-mailed to you.
Step 3: Login. Once you receive your temporary password, you are ready to login under the User Login section of MDR. Enter your e-mail
address under the “username” section and your temporary password in the “password” section. Click the “Go” button.
Step 4: Permanent Password. Once you are logged in, you should change the temporary password that was e-mailed to you. Simply click on
“Change Password” located on the left side of the page. Enter the temporary password under the “Old Password” section, and enter your new
password under the “New Password” section and in the extra box. Click the “Save Button”.
PRINTING REPORTS
To print a copy of your dose history, simply click on the “print results” button. To log out of the system, click on the “log off” tab .
Badge type
Unique Badge ID
Unique Badge ID