MIDLAND BT2 User Manual

Page 10

Advertising
background image

10

Voice activation (VOX):

› This is the default enabling mode. To start an Intercom

communication, simply start talking. The communication

will remain active for all the time you are talking. If there

is no conversation, the Intercom feature is automatically

disabled after 20 seconds.

Attention: the first Intercom activation must be done ma-

nually by pressing the Intercom button. After that, the

VOX activation will be available.

To re-enable it, simply start talking again. When the Inter-

com is “VOX” activated, you can decide to disable it before

the predefined time, simply by pressing the Intercom but-

ton once.

› To disable the voice enabling mode, follow the instructions

provided in the “Special configurations” section.

Attention: when you use the Intercom feature, the first

time you activate it (voice or manual) the communication

will be established with a short delay because of the fact

that the devices must first recognize each other. After

that the communication will be immediately established.
Two Midland BT2 units can communicate up to a maximum

range of approximately 200 meters outdoors. It is therefore

possible to use BT2 as Intercom system for “BIKE-TO-BIKE”

communications between two riders. The maximum range de-

pends on the environment the units are being used in.

Using the telephone feature

To use the Telephone feature, be sure both units are turned on

and correctly paired together, following the pairing procedure

described in section “Pairing the unit with a mobile phone”.
Attention: information provided in this section refers to

the establishment of a direct communication between

the mobile phone and the BT2 unit. If the mobile phone is

connected via the GPS Sat-Nav, the mobile phone featu-

res can only be managed via the GPS itself.
Priority: Calls are always private and have a high priority,

which means that all other communications are tempo-

rarily disabled when a call arrives and automatically re-

enabled once the call ends.
Answering a call

When you hear the phone ring, you can answer in two different

ways:

Vocally:

Simply say one word to answer the call and start talking. Re-

membering that you can only do this if you answer the call

after the third Ring. (Be aware that some phones may not sup-

port voice answering)

Manually:

Tap the “Phone” button and start speaking.
Attention: Remember that you can answer the call only

after the third Ring.

Rejecting a call

If you don’t wish to answer, you can let the mobile phone ring

or press the “Telephone” button for a few seconds (you will

hear one audio confirmation tone).

Making a call

There are several ways to make a call.

From the mobile keypad:

Dial the number on the mobile keypad:

› Press “Send” on the mobile phone.

› This way of calling should never be carried out whilst in

charge of a moving vehicle.

To redial the last number:

› Press and hold “Telephone” button for 3 seconds in order

to redial the last number (you will hear one audio confirma-

tion tone).

To make a voice call:

› Briefly press “Telephone” button. If your mobile phone sup-

ports voice calls, you will be asked to spell the name of the

contact you wish to call.

The correct operation of this feature depends on the type of

helmet used (Open or closed faced) and on the speed you are

travelling at. We suggest you perform a few tests to determine

the best settings for you as an individual.
Attention: if you are listening the music using an MP3

Player connected via Bluetooth (A2DP protocol), you will

not be able to use the “Dial last number” and “Voice call”

commands, because these buttons are used to control

the MP3 player. Therefore, if you want to make a call, you

must first disable the music by pressing the “Intercom”

button for 1 second (you will hear two audio confirmation

tone) before making the call.
Ending a call

There are several ways to end a call:

› Wait for the called person to end the call.

› Press the Telephone” button for 3 seconds (you will hear

an audio confirmation tone).

› Press “End” button on the mobile phone. (This way of en-

ding a call should never be carried out whilst in charge of a

moving vehicle)

Advertising