MIDLAND G11V - Manual (Page 29)

Midland G11V instruction guide | 11
Reception is fragmen-
ted and/or disturbed
The signal is very weak.
Try temporarily to
disable the Squelch by
means of the Monitor
feature.
The transmission di-
stance is excessive and/
or there are obstacles in
the transmission path
Move closer to the par-
ty you are communica-
ting with or to another
area.
Other parties are using
the same channel
Check the traffic on the
radio channel by means
of the Monitor feature
and select another
channel if required.
The radio has been
installed too close to
equipment that causes
interference (televi-
sions, computers, etc.)
Increase the distance
between the radio and
this equipment.
Transmission is not
always possible
The channel is used by
an excessive number of
parties or the transmis-
sion has been barred
due to a busy channel.
Select another channel.
Ask the radio link provi-
der to disable the block
due to busy channel.
VOX causes the radio
to accidentally enable
transmission
The sensitivity and/or
environmental
noise is too high.
Reduce the VOX sen-
sitivity.
The VOX feature requi-
res speaking in a loud
voice
The sensitivity is too
low.
If the environmental
noise is not high,
increase the sensitivity
or use an optional
microphone.
The autonomy of the
battery pack is limited
Commission time is too
high.
Try reducing the
transmission time and/
or using a low power.
Logic related faults
(unreadable displayed
symbols, functions
blocked, etc.)
Incorrect setting cau-
sed by a problem with
the power supply.
Recharge the battery
pack