MotorVac SteerClean 1000 - Manual (Page 15)

Appendix A - Maintenance
Maintenance Procedures
The following maintenance procedures should be performed on a routine basis:
1.
Carefully clean the exterior with a soft cloth to keep the cabinet looking new.
2.
Check all hoses and wires for cuts or frays.
3.
Clean the unit’s filter screen after every 100 services or
6 months, which ever comes first. See the next section for procedure.
Cleaning The Unit’s Filter
1. Remove the back panel.
2. Place suitable catch tray under filter assembly.
3. Filter is the Plastic ‘dome’ located in the hose from the tank.
4. Hold the bottom half of the filter while rotating the other half of the filter
counter-clockwise until the four lock tabs clear. (Press & turn like a radiator
cap) Then separate the two pieces by lifting by pulling apart.
5.
Use a fine pick or bent pin to pull screen away from the filter housing. Clean
screen.
6.
Assemble in reverse order. NOTE: Use caution not to pinch o’ring on
reassembly
7.
Enter initials, date, and a check mark in the appropriate boxes of the
Maintenance Record at the end of the chapter.