MPM MBL-01M - Manual (Page 13)

13
GB
operation saFety instructions
● Before use, thoroughly read the operation manual
● Do not hold the appliance with wet hands
● The appliance should be stored far from water.
● Always switch off the appliance setting its switch to the position 0 (OFF)
● Do not immerse the appliance, its cord and plug in water or any other fluids
● Extreme care is required in case of children presence in vicinity of the appliance.
● Do not hang the cord on any sharp edges and prevent any contact with hot surfaces.
● Prior to commencing the work, check if there are no hard tools left by mistake in the
blender jar (e.g. spoon, spatula), otherwise irreparable damage of the appliance or inju-
ries are possible
● Prior to commencing the work, check if the blender jar is properly fixed on the blender
housing
● Prior to commencing the disassembling wait until the motor will be stopped complete-
ly
● Proceed with extreme care in case of any contact with cutting edges, particularly in case
of their removal and cleaning
● Do not immerse the blender housing in water or any other fluids.
● Do not exceed the maximum volume indicated on the blender container.
● In case of hot products, allow them to cool down before their processing
● Wash the blender jar thoroughly before its first use
● Do not use the appliance in case of its damage, also if its cord or plug is damaged – in
such case the appliance should be handed over to an authorized service shop for repair.
● The use of any accessories not recommended by the manufacturer may result in damage
of the appliance, fire or injuries.
● Always pull out the plug from the socket immediately after the end or its use and before
its cleaning.
● Never leave your barbeque grill without supervision while it is switched on.
● The appliance should not be placed on hot surfaces.
● The appliance must not be used outdoors.
● The appliance should be placed on a dry, flat and stable surface.
● The appliance has been designed for the use in household only.
prior tHe First use
- Do not put your hands or other objects into the blender in course of mixing in order to
avoid injuries or destruction of the appliance. In case of necessity to remove any residu-
als of products, first switch off the blender and pull the plug from the socket and remove
the residuals by means of rubber or plastic spatula.
- The cutting blades of the blender are very sharp. Therefore never install them without
previous correct installation of the blender jar.
- Tighten the blender base.
- Always use the blender with installed jar.
- Always hold the jar in course of mixing
- Remove the hole plug from the jar lid when mixing warm products
MBL-01.indd 13 12-01-09 13:24:39