Multichannel Systems nanoZ manual - Manual (Page 7)

3
6. If the update is interrupted or cancelled the nanoZ may not function properly.
Repeat these instructions to upload the firmware completely.
It is advisable to update both the firmware and the software suite to the most recent
versions at the same time. Older firmware and device drivers may not work properly
with the latest software, and vice versa.
The latest software and firmware updates can be obtained from the download
page of your vendorʼs website, or from here: http://whitematter.serveftp.net.
Setting
up
the
nanoZ
The nanoZ requires no additional hardware other than a PC with a USB port.
`
A simple way to mount the nanoZ is with a
regular laboratory retort stand and a three-
prong clamp. Position the nanoZ over a
beaker of saline (or plating) solution. With this
setup, it is easier to put the beaker on a
height-adjustable laboratory jack and raise or
lower the jack to immerse the probe in the
solution, rather than adjusting the height of
the nanoZ on the stand.
probe
connector
USB port
future I/O
(some models)
thread
mount
LED
indicators