DefenderWorx H2 HERITAGE SHIFTER - Manual

H2 HERITAGE SHIFTER
INSTALLATION INSTRUCTIONS
Set emergency brake. Partially turn key, depress brakes while shifting gear into drive position.
Remove torx-head screw (T15) from original shift lever and insert torx-head screw into the new
shift lever. Thread the screw a minimal amount and bring shifter down so that the rectangular
section is almost even with the black strip located on the shift console. Make sure the screw sits
fully into the small hole in the metal tube. Once shift lever is properly tightened, you should be
able to work it by pushing down to change gears.
Defenderworx, Inc.
1120 North Armando Avenue
Anaheim, CA 92806
(714) 630-9700 Phone
(714) 630-9701 FAX
www.defenderworx.com