Diamond Products CC110D-SS - Manual (Page 29)

KA-08-034.0
cantrak 2600 and 2610
HArdwAre
Micro Controller
FLASH Memory
RAM
EEPROM Siemens 164, 16 bit/ 20Mhz
512K bytes
128K bytes
2600 - 2K bytes; 2610 2K + 32K bytes
electricAl
Display
Resolution
Power Requirements
Power Consumption
Audible Alarm
External output
Wiring Protection
Connection
Communications FSTN
160 x 128 pixels
10 to 32 VDC supply (reverse polarity protected)
40mA (backlight off) 160mA (backlight on) at 12VDC
4kHz Internal sounder
Open collector, internal driver (CANtrak 2610 only) 500mA
Polarity reverse protected (Fuse must be included)
Integral Deutsch 12 way connector (DT04-12PA)
Full CAN 2.0B controller/ port. RS232, J1587/J1587 (RS485)
environmentAl
Operating temperature
Storage Temperature
Degree of Protection
Salt Spray
EMC 2600: -25°C to + 75°C 2610: -40ºC to + 75ºC
-40°C to + 80°C
IP67
IEC 60068-2-52: 1996
IEC 61000 and EN55022
mecHAnicAl
Case material
Dimensions ABS housing and acrylic lens
110mm x 110mm x 38.5mm deep (4.33” x 4.33” x 1.5”) without connector
pArt numbers
CANtrak 2600
CANtrak 2610 900601
900602
mounting and dimensional information
• Excellent sunlight
readability
• Integral Deutsch 12 way
connector
• Internal 500mA open
collector output driver
(possible for external
output alarm)
– Model 2610 only
• Connector Pin
Identification:
1. Power –ve
2. Power +ve
3. RS232 TX (+)
4. RS232 TX (-)
5. RS232 RX (-)
6. RS232 RX (+)
7. CAN LO
8. CAN HI
9. J1708 / J1587A
10. J1708 / J1587B
11. Switched output
(2610 only)
12. Not Used
specifications & technical data
29