ADT Security Services Safewatch Pro 2000 - Manual (Page 27)

– 27 –
TESTING THE SYSTEM
(TO BE CONDUCTED WEEKLY)
Using the
5 TEST Key
The TEST key puts your system into the Test mode, which allows each protection point to be
checked for proper operation. The touchpad sounds a single beep every 40 seconds as a
reminder that the system is in the Test mode.
N o t e : An alarm message will not be sent to your Customer Care Center during the following
tests.
1. DISARM THE SYSTEM. Disarm the system and close all protected windows, doors, etc.
The READY indicator light should come on if all zones are intact (i.e., all protected windows,
doors, etc. are closed.
AC
ENGLISH DISPLAY TOUCHPAD
*** DISARME D ***
RE ADY TO ARM
CUSTOM DISPLAY TOUCHPAD
TEST
2. + 5 Enter the security code, then press TEST key.
(Security Code) Example: 7 2 9 6 then press the TEST key.
3. Listen. The external sounder should sound for 1 second and then turn off.
If the sounder does not sound, CALL FOR SERVICE IMMEDIATELY.
4. Fault zones. Open each protected door and window in turn and listen for three beeps
from the touchpad. Identification of each faulted protection point should appear on the
display. The display will clear when the door or window is closed.
(Continued)