Nova-Tech PTS Series - Manual (Page 10)

8 Adam Equipment 2011 ©
3.0 INSTALLATION
Please follow the installation instructions to ensure correct operation of your
PTS. In transportation the handle is removed from the truck, this needs to be
installed following the instructions below:
NOTE: Do not lower the handle down fully until completing the instructions
below.
1) Insert the roller pin into the hole of roller rack, securing the handle to the
frame.
2) Fit the split pin through the holes provided.
3) Pass the chain through the center hole of the roller pin. Secure the end of
the chain to the slot on the end of the unloading plate.
4) Remove the transit rod before use. Press the handle down only far enough to
release any pressure on the transit rod, then pull the transit rod free.