AEG DD 8695 - Manual (Page 8)

69
will automatically turn off after 5 minutes.
To interrupt the Intensive speed, press button 1 or 6.
The letter P appears on the display and the remaining time (the
point “a” is flashing), if interrupted an acoustic signal is heard.
7 - Self-Timer: times all the speed levels (the point “b” is flashing),
and then the cooker hood switches off:
The self-timer is set as follows:
1 st speed level 20 minutes
2 nd speed level 15 minutes
3 rd speed level 10 minutes
P (intensive) speed level: 5 minutes
The display shows the remaining operation time, at the end of the
time an acoustic signal is heard. Depressing the push-button
again exits the function.
Automatic Sensor calibration:
The automatic calibration is carried on by the hood itself every 30
minutes.
When the hood is installed for the first time or the power is cut off
for many hours or days, please wait 30 minutes before the use or
make a manual calibration.
Manual Sensor calibration
Carry out calibration with the hob off, at normal ambient room
temperature and in the absence of an appreciable amount of
steam:
- press switch 4 for about 3secs , then press switch 1, the hood
emits a sound signal to indicate calibration taking place.
Sensors test
When functioning in Automatic mode, the system continuously
tests the efficiency of the sensors. In case of a fault the display
shows “88”. Contact your local Service Force Centre.
In this situation the hood can, in any case, be used in the manual
mode.
Safety procedure
Self-activation of Automatic (SAFETY) mode:
if the sensors reveal an excessive increase in temperature,
even if the hood is in Manual mode, the system self selects the
Automatic mode and the hood selects the necessary speed.
The hood can be turned off by pressing push switch 1.
Should the hood or the controls fail to operate: disconnect the power
supply for at least 5 seconds.
After reconnecting the power supply wait 15 seconds and then check
that the cooker hood is now operating correctly.