Asus Motherboard K7M - Manual (Page 19)

ASUS K7M User’s Manual 19
3. HARDWARE SETUP
Motherboard Settings
3. H/W SETUP
3) Voltage I/O Setting (VIO)
This jumper allows you to select the voltage supplied to the DRAM, chipset,
AGP, and PCI, among others. The default voltage is set at 3.4V. A higher voltage
is used for processor overclocking.
Setting
VIO
3.31V [1-2]
3.4V [2-3] (default)
3.56V [3-4]
K7M I/O Voltage (VIO) Selection
3.31 Volt 3.4 Volt
1 2 3 1 2 3
VIO
4 4
3.56 Volt
1 2 3 4
01 01 01
K7M
WARNING! Using a higher voltage may help when overclocking but may result
in the shortening of your computer component’s life. It is strongly recommended
that you leave this setting on its default.
4) Onboard Audio Setting (available on audio model only)
The onboard audio CODEC may be enabled or disabled using all of these jump-
ers. Disable the onboard audio CODEC if you are using an ISA or PCI audio card
on any of the expansion slots or a primary AMR on the AMR slot (see AMR Slot
later in this section). If using an ISA or PCI audio expansion card, Onboard AC’97
Audio Controller in 4.4.5 Peripheral Setup must also be disabled.
Setting
AUDIO CODEC
Enable [1-2] [1-2] [1-2] [1-2]
Disable [2-3] [2-3] [2-3] [2-3]
K7M Audio Codec Setting
Enable
Onboard
Audio Codec
1
2
3
1
2
3
SPK
AUD_EN1
A
UD_EN2
ADN#
SPK
AUD_EN1
AUD_EN2
ADN#
Disable
Onboard
Audio Codec
01 01 01
K7M