Nova-Tech Pulsafeeder OMNI DC2-DC6 - Manual (Page 23)

19
8. Replacement Parts
8.1 KOPkit Program
OMNI ® KOPkits contain all replacement parts normally used in a preventative maintenance program.
(PULSAlube grease is also available separately for preventative maintenance programs. Refer to
Section 6 – Equipment Startup). There is a specific KOPkit for every OMNI
®
pump model. Each
KOPkit is vacuum-packed for extended storage. All OMNI ® pumps have the KOPkit number identified
on the pump nameplate and Pulsafeeder order documents. KOPkits can also be selected from the
technical data sheet shipped with the pump or by a Pulsafeeder representative. A list of the OMNI
KOPkit numbers can also be found on the next page. The kit is identified by the model number of the
pump, the wetted end material, and the process connection thread type. For models with tie-bar type
check valves, the appropriate components (check valve balls, seats, and o-rings) are supplied instead of
the cartridges pictured.
Figure 16, KOPkit parts
8.2 Ordering KOPkits or Parts
When ordering replacement parts always specify:
• Pump model and serial number (from pump nameplate), e.g., Model No. (DC-2) with Serial No.
F406365-3.
• Part number and description from the OMNI ® parts list. Include the three-character suffix. (Note:
OMNI part numbers begin either with the letters NP, or the letter W, e.g., NP170001-THY or
W210221-001.)