Pach and Company ARFR - Manual

WIRING DIAGRAM
INTRODUCTION
Pach and Company thanks and congratulates you on the
purchase of your Radio Frequency Receiver (ARFR) and
Transmitter (ARFT). The
Radio Receiver and transmitter are designed specifically for
AeGIS 4000P, 7000P Series and 8000P Series. Limited to
15 transmitters
SPECIFICATIONS
Power Input: 11-24 VAC/DC
Relay: Single relay, dry contact output
ARFT, ARFHT AND ARFANT ARE SOLD SEPERATELY
The optional ARFANT extends the RF receiver range up to
1200 feet (open air) with existing remotes. The ARFANT
comes with a 9 feet cable which easily plugs into the 3-pin
antenna port located on the ARFR motherboard (see image
below).
PROGRAMMING THE ARFT AND ARFHT
1. Press Program Switch for three seconds. The green LED
(channel 1 Status LED) will start to clash quickly
2. While the green LED flashing quickly, press the transmitter
button. The green LED will flash once and then turn off to
show that the button was learned. (The green LED will flash
for 15 seconds (programming mode) then turn off.
3. Repeat steps 1 and 2 to program more button
1. The receiver will only learn the code button once. The LED will turn steady ON for 1 second if try to program
same button
2. The receiver will take up to 15 transmitters. If attempting to program more than 15 transmitters, the first
transmitter code will be deleted from the receiver (first in, first out)
3. CLEAR ALL CODES, press Program Switch for three seconds. When the green LED starts flashing, press the
Program Switch again for three seconds. The LED will flash twice to indicate that all codes are deleted