Antec VP450 User Manual
Page 5
5
4.
Connect the 6-pin PCI-E connector to your graphics card (if applicable).
5.
Connect all Molex/SATA connector(s) to your hard drives, optical drives (CD/DVD/BluRay™) and other
accessories. Please note that some devices will use either the older 4-pin Molex connectors, while others will
use the newer 15-pin SATA connector. 4-pin Molex connectors have two black wires, a yellow, and a red. The
SATA connector has an additional orange power wire.
6.
Connect your floppy drive (if present) using the supplied FDD connector shown in Table 2.
7.
When you have all the connections secured, connect the AC power cord to the power supply AC inlet, making
sure the use the heavy-duty cord supplied with your VP450. Turn the switch on the PSU to the “|” position.