Aiwa UZ-PS128 - Manual (Page 12)

12
Recording from another audio device
You can connect your player to another audio device, such as a CD player, and record audio from
that device. The audio is converted into MP3 files and stored in the player’s internal memory.
Note
The volume and sound quality of the audio from the connected external audio device will affect the recording.
Be sure to adjust the volume and turn off sound effects on the external audio device before recording.
You can check the playback volume of the external audio device by connecting the player as ordinary stereo
headphones with its power turned off (see “Using the player as stereo headphones” on page 15).
1
Connect another audio device.
Connect the supplied analog connection cord to the INPUT (analog audio input) jack of the
player and to the headphones jack of the other audio device.
2
Set the POWER switch to ON/STANDBY to turn on the player.
3
Press and hold REC/ERASE for more than one second on the player.
A short beep sounds in the headphones and the OPE indicator lights up in red.
4
Start playback on the connected external audio device.
Recording starts.
While recording, you can listen to the audio of the MP3 files the player has created at a
sampling frequency of 44.1 kHz and bit rate of 128 kbps.
To stop recording
Press REC/ERASE.
Note
If there are no operations for more than 180 seconds in stop mode, the power will turn off automatically.
INPUT
REC/ERASE
POWER OPE
OFF ON/STANDBY
to the headphones
jack
CD player,
cassette recorder,
etc.
Analog connection cord (supplied)