Frost protection – Bosch TES50358DE VeroCafe Latte Kaffeevollautomat Dunkelbraun Silent Evening User Manual

Page 43

Advertising
background image

39

en

TES503.. | 02/2014

N.B.: If the water filter is activated, the

display will prompt you to remove the

filter and then press the

start button (10)

again. Remove the filter now if you have

not already done so. Press the

start

button (10).

Fill descaler

Press start

● Pour lukewarm water into the empty

water tank (16) up to the

0.5 l mark and

then dissolve 1 Bosch descaling tablet

TCZ8002 in it. When using TCZ6002,

2 tablets must be dissolved.

● Press the

start button (10).

Calc‘n‘Clean in progress

The descaling pro gramme will now run for

about 10 minutes.

Place container

Pull milk frother

● Place a receptacle with a capacity of at

least 1 litre under the outlet (6c).

● Pull the milk frother (6) to open it.

Calc‘n‘Clean in progress

The descaling pro gramme will now run for

about 12 minutes.

Clean / Fill water tank

Press start

● Rinse the water tank (16) and refill it with

fresh water up to the

max mark.

● Press the

start button (10).

Calc‘n‘Clean in progress

The descaling pro gramme now runs for

about 30 seconds and rinses the appliance.

Push milk frother

● Push the milk frother (6) in to close it.

Calc‘n‘Clean in progress

The cleaning pro gramme will now run for

about 8 minutes.

Empty drip tray

Insert drip tray

● Empty drip tray (8) and replace them.

Replace the filter if one is being used. The

appliance has finished cleaning is ready for

use again.

Important: Wipe down the appliance using

a soft, damp cloth to immediately remove

any descaler residue. Such residue can

cause corrosion. New sponge cloths may

contain salts. Salts can cause rust film

on stainless steel and must therefore be

washed out thoroughly before use.

Frost protection

¡

To avoid damage from low tempera-

tures during transport and storage,

the appliance must be completely

emptied first.

Note: The appliance must be ready for use

and the water tank (16) filled.

1. Place a large receptacle under

outlet (6c).

2. Press the

h

button (11).

The

h

button (11) flashes and the

appliance now heats up for approx.

20 seconds. The display then shows

Pull milk frother

.

3. Open the milk frother (6) by pulling

it out and release steam for about

15 seconds.

4. Switch the appliance off at the power

on/off switch

O / I (9).

5. Empty the water tank (16) and the

drip tray (8).

Advertising