American Dynamics ADCC1100 - Manual (Page 24)

18
ADCC1100
Holding a Tour
A tour can be stopped and held on a single camera entry by pressing the HOLD soft
key. While a tour is on hold, all keyboard control actions (pan, tilt, lens adjustment,
auxiliary on/off functions) can be performed on the held camera.
Note: after the HOLD soft key is pressed, its caption changes to RUN—see Restarting
a Tour on Hold below.
Restarting a Tour on Hold
To restart a held tour, press the RUN soft key. The tour will continue running from the
point at which it was previously held.
Stepping through a Tour
When a tour is running, the INCREMENT / DECREMENT CAMERA keys can be used
to step through the tour.
To step through a tour:
1. To step forward press the ▲ key.
2. To step backward, press the ▼ key.
Reversing a Tour
When a tour is running, the INCREMENT / DECREMENT CAMERA keys can be used
to reverse the direction of a tour.
To reverse the direction of a tour:
1. Press the ▼ key once. Note, to again reverse the tour, press the ▲ key once.
Stopping a Tour
A running system or scratch-pad tour can be stopped by either pressing the HOLD soft
key, or by calling a camera to view on the selected monitor.
Calling a Scratch Pad Tour
Each monitor can have a stored scratch-pad tour (a temporary tour programmed by the
operator).
To call a scratch-pad tour:
1. Select the monitor for the desired scratch-pad tour (ensure that there is no tour
currently running on the selected monitor).
2. Press the RUN soft key.