Bosch TES71251DE VeroBar AromaPro 100 Kaffeevollautomat silber - Manual (Page 53)

49
TES7.. | 08/2013
en
Empty drip tray
Replace drip tray
● Empty the drip tray 23 and reinsert it.
The appliance is ready for use again.
Calc‘nClean
Duration: approx. 36 minutes.
Calc‘nClean combines the separate func-
tions of descaling and cleaning.
If both programmes are due to be run soon,
the espresso machine automatically
suggests this service programme.
Cleaning and service
Short rinse
milk system
Calc‘nClean

start
The start button 8 flashes while the different
Calc‘nClean processes are running. The
figures on the top right indicate the progress
of the programme.
Important: If there is a water filter in the
water tank 11, it needs to be removed
before the service programme is run.
● Press the à button 3.
Calc‘nClean  start
● Press the start button 8; the display 5 will
guide you through the programme.
Empty drip tray
Replace drip tray
● Empty the drip tray 23 and reinsert it.
● Swivel the coffee outlet 9 to the right until
it clicks into place.
Place 1 l container
Place suction pipe in container  start
● Place a container with a capacity of at
least 1 l under the milk frother 10.
● Place the end of the suction pipe 10d in
the container.
● Press the start button 8. The appliance
rinses twice.
Cleaning
Open powder compartment
● Open the powder compartment 18.
Insert Bosch cleaning tablet
and close drawer
● Drop a Bosch cleaning tablet in the
drawer 18 and close.
Remove filter  start
Info: If the water filter is activated, the
display will prompt you to remove the filter,
then press the start button 8 again.
Add 0.5 l water and descaler  start
● Pour lukewarm water into the empty water
tank 11 up to the “0.5 l” mark and then
dissolve two Bosch descaling tablets in it.
● Press the start button 8. The descaling
programme now runs for about
20 minutes.
Descaling
Not enough descaling fluid.
Refill fluid  start
Info: If there is not enough descaling solu-
tion in the water tank 11, the corresponding
prompt is displayed. Pour in descaling solu-
tion and press the start button 8 again.