Document Outline

• 10.
• 11.
  • NOTE: When registering the INTEGRAL LAN for
• NOTE: When registering the INTEGRAL LAN for second time or registering another
  • Using the INTERGAL LAN in Network Mode
  • Sharing the INTEGRAL LAN on a Network
  • WARNING:
    • NOTE: If you cannot see your NDAS Device, please click Refresh Status and check again.
• NDAS Device Management
  • NDAS Device Status Modes
    • INTEGRAL LAN
    • Mode/Meaning
    • Bind
    • Green
    • Blue
    • White
    • Black
    • Red
    • Yellow
  • Register a New Device
  • Exit
  • WARNING :
  • NDAS Device Management Menu
  • Frequently Asked Questions
• NDAS Bind Management (Advance user only)
  • WARNING :
    • Disclaimer:
      • There are three ways to bind: Aggregation, RAID0 and RAID1.
    • AGGREGATION
    • STRIPE (RAID 0)
    • MIRROR (RAID 1)
    • The Bind Management Restrictions:
  • The Bind Management Window
  • Bind: Used for Aggregation, RAID 0, and RAID 1
  • Unbind: Used to Unbind your Bound INTEGRAL LAN
  • Tools: There are two different functions in Tools:
  • Refresh: Used to refresh status of the INTEGRAL LAN
  • Binding two or more INTEGRAL LAN
  • 1. Before INTEGRAL LAN can be Bound, they must be in Connected Mode (white icon in
  • 2. To start Bind Management software you need to go
  • 3. Click the Bind button.
  • 4. Choose a binding type and number of disks to
  • 5. Move the chosen NDAS devices from the left
  • 6. Two warning messages will appear:
  • 7. Your NDAS Devices should now be bound. Go to the NDAS Device Management and
  • 8. Found New Hardware Wizard may appear. Click Next and proceed in finishing the wizard.
  • 9. Before Bound NDAS device can be used, it must be formatted. Please go to "HOW TO PARTITION
    • THE EXTERNAL HARD DISK".
  • Unbinding INTEGRAL LAN's
    • Note: If the bound NDAS device is in use, a warning message will appear.
  • Bind Tools:
    • Add Mirror
      • Note: A NDAS device must be in a Connected Mode and have the Write Key.
    • Recover Tool
    • Note: NDAS device must be in a
• USB Mode Connection
  • Hardware installation
    • NOTE: enclosed CD driver disk is not required
    • NOTE:
      • CAUTION! Do not connect USB cable and Ethernet cable at the same time.
  • Software installation
    • Windows Me / 2000 / XP
  • Using the INTEGRAL LAN Device
    • 1.
  • Disconnecting the INTEGRAL LAN
    • WARNING!!
  • How to partition the INTEGRAL LAN disk
    • WARNING!!
      • Disk Partition/Formatting
    • WARNING!!
      • Windows 2000/XP
        • Step1
        • Step2
        • Step3
        • Step4