PROLiNK PHA5010-Gold - Manual

PHA-5010-Lite
PHA-5010-Gold
Key Features
Up to 8km LOS range with integrated 18dBi antenna*
Outdoor waterproof IP65 Casing
Up to 108 Mbps (Turbo Mode)
MAC filtering & Remote AP Association Control
WPA, WPA-PSK, WEP and AES security
Bandwidth control with QoS VOIP and video.
Web and SNMP management.
Wireless Features
• IEEE 802.11a/h compliant radio, up to 54Mbps
• Support DFS and TPC.
• RF Power control between 100% to 12.5% of max power
• Support seamless roaming within the same subnet
between Access Point
• Best for used as Wireless Bridge Client (CPE)
• Support with or without wireless distribution system
(WDS)
Network (Internet and Intranet)
• Protocol Filtering
Security and Access Control for Client Mode
• Support static WLAN WEP up to 152 bits encryption
• MAC Address Control
• WPA with Radius Server for EAP-TLS, EAP-TTLS and EAP-
PEAP (In Access Point mode)
• WPA-PSK (AES and TKIP)
• Wireless to wireless user isolation
Management
• Web-based management
• SNMP V1 & V2c management
• IP address discovery software (Viper Quick Start)
• Firmware upgradeable through web-server and telnet
Hardware
• Chassis Type: IP65 Rating with Bracket for pole mounting
• Ethernet Port: 10/100 Base-T auto MDIX
Power Specification
• Power adapter: 18~48V DC through RJ45
• Power Consumption: Typical 6.5 Watts, 7.0 Watts Max
Environment
• Operating Ambient Temperature: 0ºC to +60ºC
• Operating Relative Humidity: 20~90% (non-condensing)
• Storage Ambient Temperature: -30ºC to 75ºC
• Storage Relative Humidity: 95% Max (non-condensing)
Specification are subject to changes without prior notice due to engineering improvement. Wireless range
and performance may vary with environment. All brands and product names are trademarks or registered
trademarks of their respective holders.
* Distance between AP based station. Distance may vary with environment.
5GHz Outdoor Rugged Fixed Wireless
802.11a Access Point / Wireless Bridge Client (CPE)
Standard Package
The standard package for AP-5010 comes with the following:
1) PHA-5010
2) 3m UTP cable (RJ45)
3) 48V DC combiner adaptor (PoE)
3) Screws, nuts, and washers
4) Mounting bracket (pole)
Ordering Model
• AP-5010-Gold: Support Access Point and
Wireless Bridge Mode.
• AP-5010-Lite: Support Wireless Bridge Mode.
RF Specification
Frequency 4.900 ~ 5.875 GHz
Wireless Data Rate 54, 48, 36, 24, 18, 12, 9, 6 Mbps
Up to 108Mbps for Turbo mode
Channels Country dependent
Transmit Power Up to 20dBm
Modulation OFDM, BPSK, QPSK, 16QAM,
64QAM
Receiver Sensitivity -90dBm for 6Mbps
-89dBm for 9Mbps
-88dBm for 12Mbps
-87dBm for 18Mbps
-84dBm for 24Mbps
-81dBm for 36Mbps
-74dBm for 48Mbps
-71dBm for 54Mbps
Built-in Antenna Gain 18 dBi (5.1 ~ 5.9 GHz)
> 14 dBi (4.9 ~ 5.1 GHz)