PROLiNK WNR1009 Wireless-N - Manual (Page 3)

6)
To setup wireless security when in repeater mode, go to Security > Select SSID: make
sure the Repeater AP is selected > Select WPA(TKIP) or WPA2(AES) as the
Encryption Mode. Pre-Shared Key Format: Passphrase. Enter your desired password
in Pre-Shared Key e.g. testing 123. The Pass Phrase entered must be a minimum of 8
characters. Click Apply Changes > Reboot Later
** WPA2, AES provides the best security. But not all wireless adaptors in notebook or
PC support it. Please check with your wireless adaptor manufacturer or notebook
manufacturer if their product support WPS2-PSK, AES
. If not sure, please choose WPA-
PSK, AES or TKIP.
7)
Go to Internet Settings > LAN Interface > Change the IP address to be in the same
range of your wireless AP e.g. if my wireless AP is 192.168.1.1, then I will input the
IP Address to be in range of 192.168.1.x > Default Gateway: the IP address of your
wireless AP e.g. 192.168.1.1 > DHCP Client Range: change the range to be in the
same subnet range e.g. 192.168.1.100 – 192.168.1.200 > Apply Changes > the router
will reboot now
That’s it, your Universal Repeater had been setup!