PROLiNK WNR1004 Wireless-N User manual - Manual (Page 52)

PROLiNK® WNR1004 User Manual www.prolink2u.com
Revision 1.0 (Apr’09)
49
Chapter 4: PC Configuration
4.1 Overview
For each PC, the following may need to be configured:
• TCP/IP network settings
• Internet Access configuration
• Wireless configuration
4.2 Windows Clients
• This section describes how to configure Windows clients for Internet access via the Wireless
Portable Router.
• The first step is to check the PC's TCP/IP settings.
• The Wireless Portable Router uses the TCP/IP network protocol for all functions, so it is
essential that the TCP/IP protocol be installed and configured on each PC.
4.2.1 TCP/IP Settings - Overview
If using default Wireless Portable Router settings, and default Windows TCP/IP settings, no changes
need to be made.
• By default, the Wireless Portable Router will act as a DHCP Server, automatically providing a
suitable IP Address (and related information) to each PC when the PC boots.
• For all non-Server versions of Windows, the default TCP/IP setting is to act as a DHCP client.
If using a Fixed (specified) IP address, the following changes are required:
• The Gateway must be set to the IP address of the Wireless Portable Router.
• The DNS should be set to the address provided by your ISP.
4.2.2 Checking TCP/IP Settings - Windows 2000
1. Select Control Panel - Network and Dial-up Connection.