PROLiNK PWH2004 User Manual - Manual (Page 24)

PROLiNK ® PWH2004 User Manual www.prolink2u.com
Revision 1.0 (Aug’09) 22
4.5.4. Advance Routing
If you connect several routers with this Wireless Router, you may need to set up a predefined routing rule to
have more effective network topology/traffic, this is called static route between those routers and the
Wireless Router.
To set static routers, enter the settings including route IP address, route mask route gateway the route
Interface from LAN or WAN.
Destination
The network address of the destination LAN segment. When a packet with
destination IP address that matches to this field, it will route to the device set in
the Route Gateway field.
Range Select Host or Net from the pull-down menu.
Gateway Enter the Gateway IP address in the field.
Interface
You can select to use LAN, WAN or Custom as the physical interface from where
the packets will be sent.
Comment Enter note or remark here.
Dynamic Routing
Settings
Select Disable or Enable form pull-dowm list to use the RIP function.
Apply After completing the settings on this page, click Apply button to save the settings.
Reset Click to discard current setting.