PSA PIN388D/PIN388L User Manual - Manual (Page 20)

PINKERTON User Manual
18
How to turn the system ON.
AWAY mode (using your User Code)
In the AWAY mode, all Zones programmed as AWAY Zones will be armed.
(Typically this means all Zones.)
The ON light should be off indicating the system is OFF.
Make sure that all protected doors and windows are shut securely. Check also
that all Zone lights on the Keypad are off, except for the Zones you use to exit
the premises. (Check that no pets are left to roam inside the protected areas -
curious cats and dogs are a major cause of false alarms).
1. Enter ....................To clear the keypad
2. Enter
BBBB
....Your User Code
(All Zone lights will flash - waiting for a command)
3. Enter ....................Arms the system in Away mode
4. Check that the ON light turns on.
(The exit beeper will sound continuously during exit delay. If the exit
beeper has been turned off by the installer, three beeps will be heard at
the end of exit delay.)
You now have a limited time to leave the premises (which will have been
preset by your installer) before an alarm is generated. If you need to re-enter
the premises, turn the system OFF, then back ON again as you leave.
NOTE: If you make a mistake when you attempt to enter your User code,
press the key and try again.