Asante Technologies 6000 Series - Manual (Page 50)

Management
Page 4-28
Configuring Spanning Tree Parameters
To configure the Spanning Tree Parameters on the IntraStack:
▲ Important: Do not change any of the Spanning Tree
parameters unless you have knowledge and experience
with the IEEE 802.1d specification.
1
Do not select any item on the front-panel image. (This
selects the entire device.)
2
Click Spanning.
The Spanning Tree Device table appears, similar to
Figure 4-17.
Figure 4-17 Spanning Tree Device table
∆
Note: For a description of each field, see “Span-
ning” on page 5-23.
3
Within this table, you can configure the following
information:
❏ Spanning Tree Priority
❏
Bridge Maximum Age
❏ Bridge Hello Time
❏ Bridge Forward Delay
4
Click once in the Spanning Tree parameter field to be
modified.
Book Page 28 Thursday, September 18, 1997 4:28 PM