Preparation using coffee beans, Preparation using ground coffee, Dispensing hot water – Bosch TES50129RW VeroCafe Machine à café Expresso automatique Noir User Manual

Page 15

Advertising
background image

11

TES501.. | 02/2014

en

Preparation using

coffee beans

This fully automatic espresso machine

grinds beans freshly for each brew.

Tip: If possible, use only beans for fully

automatic coffee and espresso machines.

For optimal quality, deep-freeze the beans

or store in a cool place in sealed containers.

Coffee beans can be ground while frozen.

Important: Fill the water tank (16) with

fresh water every day. The water tank (16)

should always contain sufficient water for

operating the appliance.

Different coffee drinks can be prepared

quite simply at the press of a button.

Preparation

The appliance must be ready for use.

1� Place the pre-warmed cup(s) under the

coffee outlet (7).

Tip: For a small espresso, always

preheat the cup, e.g. using hot water.

2� Select the required coffee and the

required quantity by turning the upper

rotary knob (14).

3� Select the required coffee strength by

turning the lower rotary knob (13).

4. Press the start button (10).

Coffee is brewed and then poured into the

cup(s).

Press the start button

(10) again to stop the

brewing process early.

Preparation using

ground coffee

This fully automatic espresso machine can

also be operated using ground coffee (not

instant coffee powder).

Important: Fill the water tank (16) with

fresh water every day. The water tank (16)

should always contain sufficient water for

operating the appliance.

Preparation

1� Open the drawer (4).

2� Put ground coffee into the drawer

(maximum two level measuring spoons).

Caution: Do not use whole beans or

instant coffee.

3� Close the drawer (4).

4. Turn the bottom rotary knob (13) to the

symbol

G

5� Press the start button (10).

Coffee is brewed and then poured into

the cup.

Dispensing hot water

¡

Risk of burns!

The milk frother (6) gets very hot. Hold the

milk frother (6) by the plastic part only.

The milk frother must be cleaned before

drawing hot water.

The appliance must be ready for use.

1� Place a pre-heated cup or glass under

the milk frother outlet (6).

2� Pull out the milk frother (6) to open it.

The appliance heats up. Hot water runs

out of the milk frother outlet (6) for about

40 seconds.

3� Stop the process by pushing in the milk

frother (6).

Advertising