Server CP-RP (85951) - Manual (Page 3)

assemBle PlungeR
apply food equipment lubricant onto seal and seal 0-Ring
install o-Rings and assemBle PumP Body
apply food equipment lubricant onto 0-Rings
install lid and seCuRe With
disChaRge tuBe nut and loCKing CollaR
PumP assemBly
Before firSt uSe And After uSe dAily, diSASSemBle
And cleAn pump.
assemBle PlungeR:
1 inStAll SeAl o-ring inSide SeAl.
• Apply food equipment lubricant on seal o-ring.
2 inStAll SeAl ASSemBly onto piSton heAd.
• Apply food equipment lubricant inside seal assembly.
• flared end of seal assembly should be facing away
from piston head.
3 inStAll WASher onto threAded end of piSton.
4 inStAll Spring onto threAded end of piSton.
5 inStAll heAd inSert inSide heAd tuBe.
• Beveled edge of head insert should be facing inside
of head tube.
6 inStAll gAging collAr(S), if needed, And
locking collAr onto heAd tuBe By Sliding
them on. poSition locking collAr With
threAding inSide locking collAr fAcing
gAging collAr(S) And/or heAd tuBe flAred
end.
7 inStAll heAd tuBe ASSemBly onto piSton
ASSemBly.
8 inStAll knoB onto plunger ASSemBly And
rotAte clockWiSe to Secure onto threAded
end of piSton.
• firmly hold head tube towards piston head,
compressing spring, while screwing knob on.
install o-Rings and assemBle PumP Body:
9 inStAll SmAll o-ring onto diSchArge tuBe.
• Apply food equipment lubricant on o-ring.
• Be careful not to damage o-ring while installing
and/or rolling onto discharge tube.
J inStAll lArge o-ring into vAlve Body.
• Apply food equipment lubricant on o-ring.
K inStAll cylinder onto vAlve Body.
• Rotate cylinder clockwise and press down firmly to
secure into slots on valve body.
L inStAll diSchArge tuBe onto vAlve Body.
• rotate discharge tube clockwise and press down
firmly to secure into slots on valve body.
install lid and seCuRe With
disChaRge tuBe nut and
loCKing CollaR:
M inStAll lid And diSchArge tuBe nut onto
diSchArge tuBe.
N Secure lid onto pump Body By rotAting
diSchArge tuBe nut clockWiSe.
O inStAll plunger into cylinder And Secure
to cylinder By rotAting locking collAr
clockWiSe.
oPtional gaging CollaRs