Teledyne 3010PA - Split architecture percent oxygen analyzer - Manual (Page 31)

3 Installation Model 3010 PA
3-10: Part I
• Check the integrity and accuracy of the gas connections. Make
sure there are no leaks.
• Check the integrity and accuracy of all electrical connections.
Make sure there are no exposed conductors
• Check that sample pressure is between 3 and 40 psig, according
to the requirements of your process.
Power up the system, and test it by performing the following
operations:.
1. Repeat the Self-Diagnostic Test as described in chapter 4, section
4.3.5.