Electronics International MVP-50T - Manual (Page 69)

A5.0 Appendix:
Adding Custom Voice Warning Files to the MVP
The MVP can be set to play a separate .wav file as a waring for each function that enters a Yellow and/or Red
operating range. Custom .wav files can be recorded (or found on the interned or your PC), installed into the
MVP and assigned as an audio waring for any function.
Recording Requirements: Recording Requirements: Recording Requirements: Recording Requirements: Recording Requirements:
Most PC’s can be set up to record .wav files. When recording, the audio
format must be set to PCM, 22KHz, 8 Bit, Mono. The files must be .wav, not MP3 or some other format.
When recording a .wav file, you should match the volume level of the existing files installed on the MVP. A
sample .wav file can be found on the USB Memory Stick (supplied with the MVP) in the “audio” directory.
Copy and play this file on your PC to insure that your record and volume settings are correct.
Record only the name of the function you want to hear. The MVP will automatically play “Ding Check”
before it plays your .wav file. For example: to be warned about a Canopy Latch, you only have to record
“Canopy Latch.” When the latch is open the MVP will play “Ding Check” then your file, “Canopy Latch.”
Keep your .wav files relatively short and professional. “.Wav” files share memory with engine data recording
files. Too many long .wav files will reduce the engine data recording time.
Downloading .wav Files to the MVP: Downloading .wav Files to the MVP: Downloading .wav Files to the MVP: Downloading .wav Files to the MVP: Downloading .wav Files to the MVP:
Note: You must have the Password to download audio files to the MVP. Non-FAA certified MVP’s are
shipped with a Password of “0100.”
Note: You may want to download and test one file before you install possibly many trashed files into the
MVP.
1. Copy the .wav files to the “audio” directory on the USB Memory Stick. Do Not store files in this directory
that you do not want installed into the MVP.
2. Insert the USB Memory Stick in the USB port on the MVP.
3. From the Main Engine Screen navigate to the “USB Flight Data File Manager” screen (i.e.: press the
“Menu” button > Select the “System Configuration Screens Menu” at the bottom of the blue screen > Select
the “USB Flight Data File Manager” screen).
4. Select “Read All Voice Files.” Enter the Password, if required, and select “YES” and push the Select knob.
Note: The available disk space on the MVP is listed at the bottom of this screen. You can delete audio files in
the lower section of this screen.
5. Exit back to the Main Engine screen by pushing the “Exit” button several times.
Page 1 of 2