FEC AFC1200 - Manual (Page 19)

)(& ,QF
7.1.7 VOCABULARY LIST 2 [FASTENING] ANGLE CONTROL
FIG. 7-1-7 set parameter [FASTENING] angle method
FULL SCALE TORQUE Maximum transducer monitoring capacity
TORQUE METHOD Torque Control method
(CW/CCW)
ANGLE METHOD Angle Control method
(CW-SNUG/CW-SEAT/CCW) * Seat Method - Angle count starts at 1st Torque Rate
(calculated zero point)
* Snug Method - Angle count starts at Threshold 2 Torque
(standard operating method)
YIELD METHOD Yield Control method
(CW/CCW)
SPEED CHANGE TORQUE Shiftpoint from 1st STep to torque speed
THRESHOLD 1 TORQUE Start of 1st TORQUE RATe measurement
THRESHOLD 2 TORQUE STart of FINAL ANgle measurement (using SNUG method)
Chapter 7: System Operation
Page 7-19