Audiovox FPE4707HR - Manual (Page 22)

Memorizing the Channels
Selecting the TV Source
Before your TV can memorize the available channels, you must
specify the type of signal source that is connected to the unit. (i.e., an
antenna or cable system)
Auto Channel Search
 Select AIR if using antenna.
 Select CABLE if using cable.
If TV Source is set to AIR: highlight Auto Search in the CHANNEL
SETUP menu and then press
or to begin the auto channel
search he unit will automatically search for all available TV/DTV
program.
4 3
, t
Channel Skip
Navigate to the CHANNEL SETUP menu.
1
2
Highlight Current Channel item, use to select an
unwanted channel.
3or4
After setting channels into memory, you can skip unnecessary
channels so that only the channels you want to watch are selected
with Channel up/down buttons.
3
Highlight Channel Skip item, use 3or4 set ON. to
5
Press EXIT button to exit.
Note:
l If you want to stop the auto-search, press MENU button.
l Select one of Cable STD/HRC/IRC according to your local area's cable system, normally please select STD.
Now when you use CH+/- buttons to cycle among the channels, the skipped channels can not be selected.
In full screen mode, press MENU to display the main menu.
1
Press to display SETUP menu page, press
to enter.
4or3 CHANNEL 6 2
3 Press to select ress or to select
AIR or CABLE.
6or 5 TV Source item, p 3 4
4 If you want to skip other unwanted channels, repeat the above
steps.
CHANNEL SETUP
TV Source
Current Channel
Channel Label
Channel Skip
Favorite Channel
Auto Search
Input Select
Signal Strength
AIR
2-1
> > >
> > >
OFF
OFF
WGBH-
Channel Scan Source
CHANNEL SETUP
TV Source
Current Channel
Channel Label
Channel Skip
Favorite Channel
Auto Search
Input Select
Signal Strength
AIR
2-1
> > >
> > >
OFF
OFF
WGBH-
CHANNEL SETUP
TV Source
Current Channel
Channel Label
Channel Skip
Favorite Channel
Auto Search
Input Select
Signal Strength
AIR
2-1
> > >
> > >
ON
OFF
WGBH-
When the TV powers on for the first time after purchase, the initial auto channel search is invoked.
This unit can automatically find all channels available through antenna or cable inputs, and store them in memory.
Note: Be sure to select the TV input ( refer to < Selecting Input Source Signal > section on previous page ) before
operation.
If TV Source is set to CABLE: highlight Auto Search in the
CHANNEL SETUP menu and then press
or ,
. or ,
, to begin the auto channel search he
unit will automatically search for all available CATV/CADTV
program.
4 3 now a Channel
Scan Source window opens up Use 4 3to select one of STD
HRC IRC and then press OK , t
STD HRC IRC
20