AEG SMART 306 - Manual (Page 8)

12
Troubleshooting
Power: If the electric power does not
come on, disconnect from mains
and check plugs, cable and fuses
where appropriate.
Blockages/dirty filters: The cleaner
may switch itself off in the event of
a severe blockage or excessively dirty
filter(s). In such cases, disconnect
from mains and allow to cool for
20-30 minutes.
Clear blockage and/or replace
filter(s) and restart.
The clearing of blocked hoses is not
covered by the guarantee.
Please also see AEG additional
information towards the back of this
booklet.
Water: If water is sucked into the
cleaner the motor must be changed
at an AEG Service Centre.