Direct Lift ROTISSERIE - Manual (Page 8)

ROTISSERIE (R3000G) 8 IN50016 Rev. B 03/30/2009
16. Apply pressure with the Balancer so you can remove the Bolt, Washer and Nut that holds
the swing arm in place, Fig. 6.
Remove this Bolt
Washer and Nut
FIG. 6
17. Raise the Swing arm up using a socket or impact wrench, being sure to move each end up
only one hole at a time. This is to prevent any binding.
18. Put the large Bolt, Washer and Nut in the next hole and tighten.
19. Back out the Balance Rod enough to swing the vehicle.
20. Test the balance by swinging the vehicle from side to side.
21. If the vehicle is still bottom heavy REPEAT FROM STEP #15 testing the balance in each
hole. NOTE: As long as you don’t jump over holes the difference from one hole to
the next is never so great as to become uncontrollable.
Hydraulic Fluid
If hydraulic fluid needs to be added to hydraulic cylinders, please use:
ISO 32 Light Hydraulic Oil