Earthway 2100P Estate Broadcast Spreader - Manual (Page 2)

Gearbox Assembly
DRIVE WHEEL SIDE
COAST WHEEL SIDE
Frame brace
¼-20 x 1¼”
Hex Head Bolt
¼-20 x 2”
Hex Head Bolt ¼-20 Locknut
Impeller
Frame
Draw Bar
Shut-Off
Flat Head
Screw
3. Install impeller onto pinion shaft. Insert 1/8”x 1¼” Cotter pin
through impeller then through pinion shaft. Use hole closest to the
gear box. Spread cotter pin to prevent from falling out.
FRO NT
Pinion
Shaft
⅛ x 1¼”
Cotter Pin
Impeller
Gearbox Assembly
Gearbox
FRONT
FR ON T
4. Install gear box by inserting the pinion shaft into hole in center of hoppers
bottom. The word “FRONT” on the gearbox must point to F
ront
of the
hopper. Follow label instructions on hopper. Next, slide axle thru the gearbox
with the drive wheel hole positioned as shown in the drawings below.
Axle Bearing
Flat
Side
Notch
5. Install axle bearings to both Drawbars.
NOTE: Notch on bearings and in the
Drawbar line up. Bearings must go through
flat side of lower handle.
6. Install lower handles onto axle to both sides as shown. Insert ¼-20 x 2” bolt through hole
in Draw Bar and through first hole in frame install locknut. DO NOT TIGHTEN. Next insert
¼-20 x 1¼” bolt through frame brace and through second hole in frame install locknut.
NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS STARTING WITH FIRST
STEP. DO NOT OVER TIGHTEN.
PAGE 2
SLIDE